Re: 308 QV Motor Swap | <– Date –> <– Thread –> |
From: Hans E. Hansen (FList![]() |
|
Date: Mon, 16 Mar 2015 10:36:16 -0700 (PDT) |
I'm using Mobil 1 15W50 and have no leaks whatsoever.
BTW, it seems that of the Mobil 1 products, the 15W50 has more phosphorous/zinc than their other products. But I put a dash of additive in there anyway.
Hans.
On Sun, Mar 15, 2015 at 5:18 PM, Robert W. Garven Jr. <rgarven [at] gmail.com> wrote:
Peter and friends,I dont have any leaks from the redline gb oil but I switched to redline synthetic 20/50 after my ast service and the ting leaked like a sieve switched back and have virtually no leaks!I did have to replace the inner flange seal and sealant!Robert W. Garven Jr."The Ferrari is a dream - people dream of owning this special vehicle and for most people it will remain a dream apart from for those lucky few." Enzo Ferrari
On Mar 15, 2015, at 4:17 PM, Peter Rychel <dino308gt4 [at] hotmail.com> wrote:http://lists.ferrarilist.com/mailman/options/ferrari/rgarven%40gmail.com_________________________________________________________________Rob mentions he uses Redline. I tried it and it was okay, but I found it leaked a lot. I switched back to Pennzoil "Gearplus" 80W90.
Peter
Date: Sun, 15 Mar 2015 18:29:15 -0400
Subject: Re: [Ferrari] 308 QV Motor Swap
From: ferrari308driver [at] gmail.com
To: dino308gt4 [at] hotmail.com
CC: ferrari [at] ferrarilist.comPeter, your point is a very good one and it has been a while since I changed the gearbox fluid anyhow. I think that is something I should do very soon. What is everyone's favorite gearbox fluid for the 308 series cars these days? I believe last time I used some version of Swepco, but it's been a while....-Matt'85 euro 308On Sat, Mar 14, 2015 at 1:06 AM, Peter Rychel <dino308gt4 [at] hotmail.com> wrote:Sounds like a good plan.
Funny you mention 2nd AND 4th gear syncros showing signs of weakness. I've found my 2nd gear not too bad, but would have the occasional "crunch" into 4th, cold or hot. Rob Garven and I were discussing this about two years ago when I was in the midst of a service and doing the O-Ring seals on the shift-shaft on my GT4. I did some measurements and noticed that the 4th and 5th gear clusters are not touching the level of oil in the gearcase (that's based off of filling the oil until it pours out of the sight hole on the backside of the trans. case). Since then, I've OVER-filled the transmission by a half liter or so (a little more than half a quart) and 4th gear shifts much better now. Maybe because it was only getting splash lubrication before, that that just wasn't enough to allow the syncro to work properly.
I've been a member of F'Chat for 15 years, but I don't log in much as I used to.
Peter
Date: Fri, 13 Mar 2015 18:14:46 -0400
From: ferrari308driver [at] gmail.com
Subject: [Ferrari] 308 QV Motor Swap
CC: ferrari [at] ferrarilist.com
To: dino308gt4 [at] hotmail.com_________________________________________________________________ To unsubscribe or modify your subscription options, please visit: http://lists.ferrarilist.com/mailman/options/ferrari/dino308gt4%40hotmail.com Sponsored by BooyahMedia.com and F1 Headlines http://www.F1Headlines.com/All,I am close to purchasing a donor motor for my 308. For the past several years I have been aware of low compression (as in about half the compression of the good side), and a leakdown reveals it needs rings. I have driven it sparingly since, and never hard (surely not at a track event). It has the original motor with well over 100k miles, and it is my goal to someday rebuild it. For the record, it is a Euro.For the f-chatters amongst us, you may have noticed a Euro 3.0 QV motor for sale from a Mondial from a fellow who did a 3.2 transplant. Thanks to George Parker for turning me onto it since I'm not a regular f-chatter. My plan is to take my motor out and KEEP it so I have a matching numbers motor, but use this one for the time being. I hpoe to rebuild it someday. My gearbox could probably use some attention with respect to the 2nd and 4th gear syncrhos, so that will require some effort as well. I'm not sure if and what else I'll do "while I'm in there" other than really cleaning things up in the engine compartment when it is vacant. Other ideas include perhaps Rick Lindsay's 308 A/C upgrade, perhaps an aftermarket ignition, but if I'm smart I'll just put it back together and enjoy it. Oh yeah, why not put those Energy Suspension bushings in that I bought years ago, maybe rebuild the Konis, etc etc....? ;-)I'm meeting the seller of the motor at Competizione (Richard Capoccia) on Monday for Richard to help me assess the health of the motor. Basically a leakdown test. Any comments/recommendations here would be appreciated.For many years, my 308 was a dependable, well-maintained, sometimes daily driver. I'm not looking for a showcar or to build performance mods in, I just think a Euro 308 is about the most beautiful car out there, and I'm fortunate to have had mine for almost 20 years now, and I want to get it back to where I wouldn't hesitate to drive it across the country and back.-Matt'85 Euro 308
To unsubscribe or modify your subscription options, please visit:
Sponsored by BooyahMedia.com
and F1 Headlines
http://www.F1Headlines.com/
_________________________________________________________________
To unsubscribe or modify your subscription options, please visit:
http://lists.ferrarilist.com/mailman/options/ferrari/flist%40hanshansen.org
Sponsored by BooyahMedia.com
and F1 Headlines
http://www.F1Headlines.com/
- Re: 308 QV Motor Swap, (continued)
- Re: 308 QV Motor Swap Robert W. Garven Jr., March 15 2015
- Message not available
- Re: 308 QV Motor Swap Robert W. Garven Jr., March 15 2015
- Re: 308 QV Motor Swap Matt Boyd, March 16 2015
- Re: 308 QV Motor Swap Robert W. Garven Jr., March 16 2015
- Re: 308 QV Motor Swap Hans E. Hansen, March 16 2015
Results generated by Tiger Technologies Web hosting using MHonArc.