The filler tube needs a open end 23mm thin and short. You need to remove the oil filler tube to drop the oil pan on the 3x8. That is a major part my Ferrari.
Stephen
Sent from my iPad No the heater hose to the compartment has its own alley to say There are no other hoses in its space thank god In victory you deserve Champagne In defeat you need it!
Scars are Tattoos with better stories !
If you follow all the rules You miss all the fun!
Clyde Romero 678 6419932
Confidentiality Notice: This e-mail ( including attachments ) is covered by the Electronic Communications Privacy Act, 18 U. S. C., Sections 2510-2521, and is intended only for the persons or entity to which it is addressed, and may contain confidential or privileged material. Any unauthorized review, use, disclosure, dissemination, copying, forwarding or distribution is prohibited. This email transmission, and any documents, files or previous email messages attached to it, may contain confidential information that is priviledged. If you are not the intended recipient, or a person responsible for delivering it to the intended recipient, you are hereby notified that any disclosure, copying, distribution or use of the information containes in or attached to this message is STRICTLY PROHIBITED. If you have received this transmission in error, please immediately notify us by reply e-mail at Clyde.romero [at] yahoo.com or by telephone at (678 6419932)and destroy the original transmission and its attachments without reading them or saving them to disk. Clyde, I know you must be kidding, just 4. open end, box end, slim (thin, example to get at the base of the oil filler tube), cheater tube to extend the wrench, several ratchets ( did you notice even when you buy sockets in a foreign country - Germany in my case - the sockets are sized for drivers in inches ) drivers, torque wrench. I would ad box cutters for hoses (water, emission and fuel - not to be used on injector fuel lines, use a heat gun, liquid wrench, wd 40, strap wrench for oil filter and don't forget crescent wrench and pipe wrench (yes I said pipe to be used on parts that are coming out/off and not going back in/on. Vise grips to convince nuts and bolt that gave up their faces to let go.
Back to the engine pipe and you take the old one off and put it on you newer engine?
I don't know if your Red Head has the heater hose that runs through the rocker panel, if it does, this would be the time to replace it and the brake vacuum is there too. The 3x8 family has them and some swear the car was built around them.
Did I pass?
Stephen
|
gmail.com)