Re: Fwd: Mission accomplished (oil lines change) | <– Date –> <– Thread –> |
From: Michel Savard (mysavard![]() |
|
Date: Fri, 22 May 2020 16:28:43 -0700 (PDT) |
No, for the 2nd question, the oil temp sender is actually between that part (with 2 green wires) and under the oil filter. That is I think the ’time thermal switch’. My mechanic changed it in 2003. There is a lot of oil there too. Maybe it is also due. There was no leak that I know of. The bottom oil line was so messy, so dirty after years of accumulations of dirt/oil, that I decided to change both. I changed the ’S’ shape oil pipe just above the lower line in 2015. THAT was leaking I know. The damage was done. I like to do one big change/repair a year. This (2 oil lines) seemed to be a good idea. Plus, it gave me the chance to clean up the block. It was so dirty all around. Every time I turned off the engine there was (I didn’t drive this year yet) such a strong smell of hot oil for a long time. Sometimes even standing at a red light with the right wind, I smell hot oil. I cleaned around the best I could. Changing the ‘oil pressure sending unit’ was by force. It is not working. The oil temp sender is working, but I may as well do it too. Michael Savard (1981 308 GTSi)
|
-
Fwd: Mission accomplished (oil lines change) Michel Savard, May 22 2020
- Re: Mission accomplished (oil lines change) Erik Nielsen, May 22 2020
- Re: Fwd: Mission accomplished (oil lines change) Lashdeep Singh, May 22 2020
- Message not available
- Re: Fwd: Mission accomplished (oil lines change) Michel Savard, May 22 2020
- Re: Mission accomplished (oil lines change) Lashdeep Singh, May 22 2020
- Message not available
- Re: Mission accomplished (oil lines change) Michel Savard, May 22 2020
- Re: Mission accomplished (oil lines change) Lashdeep Singh, May 22 2020
- Message not available
- Power door actuator Michel Savard, May 23 2020
Results generated by Tiger Technologies Web hosting using MHonArc.