Ferrari Mailing List: Re: Probable explanation for my horn problem!

[Michel Savard (mysavard]

It’s these kinds.

Michael

On Jun 3, 2024, at 11:54 PM, Peter Rychel <dino308gt4 [at] hotmail.com> wrote:

The only way you can make it tighter is to gently squeeze the connector with a pair of pliers. This way it will grab the male spade part on the fuse box better.

See my picture (attached to this email).

Peter 

---

From: Ferrari <ferrari-bounces+dino308gt4=hotmail.com [at] ferrarilist.com> on behalf of Michel Savard <mysavard [at] videotron.ca>
Sent: June 3, 2024 3:36 PM
To: PeterGT4 <dino308gt4 [at] hotmail.com>
Cc: The FerrariList <ferrari [at] ferrarilist.com>
Subject: [Ferrari] Probable explanation for my horn problem!

 

Today, I decided to check the fuses. I tested a couple of relays (0332019151) yesterday and all were good.
In april 2023 I put the Birdman’s fuse boxes in. I just noticed the #16 (horn) was quite loose. It was easy to push it up and down. Still a bit tough to take it out but can this have been the problem ?
#17 (right fan) was quite loose too. Both fan worked yesterday by the sound of it, I didn’t check if BOTH worked.

If this was the origine of my  problem, meaning horn not working only when engine running, how do you get these things tight ? I tried with my thumb finger nails, but to no results. I couldn’t find a tiny enough screwdriver blade.
Any ideas ?

If that was the problem, now I only need to figure out the mess I made with the ground wire attached to the horn button.

Michael Savard (1981 308 GTSi)
_________________________________________________________________
To unsubscribe or modify your subscription options, please visit:
https://lists.ferrarilist.com/mailman/options/ferrari/dino308gt4%40hotmail.com

Sponsored by BooyahMedia.com
and F1 Headlines
http://www.F1Headlines.com/

<BladeConnector.jpg>