Ferrari Mailing List: Re: <NFC>removing broken screw question

[Misc (misc]

Drill a VERY small hole, then use an appropriately sized small Easyout tool
to un-thread it.

Mark Lueker
308 SYSTEMS Inc.
970-282-7006
www.308systems.com

-----Original Message-----
From: Lee S. Lingo [mailto:lslingo [at] comcast.net]
Sent: Monday, January 12, 2009 2:24 PM
To: Mark
Cc: The FerrariList
Subject: [Ferrari] <NFC>removing broken screw question


In my effort to replace a burned out bulb in my taillight, a screw broke in
two.  They have grown rusty and are rather narrow so it was no surprise.
I'm able to take the top off the clam-shell and have access to the top of
the remainder of the screw, but I'm not sure how to remove the tip.  There's
not enough exposed to grab with needle-nose pliers.  Any suggestions?



Lee

_________________________________________________________________
To unsubscribe or modify your subscription options, please visit:
http://lists.ferrarilist.com/mailman/options/ferrari/misc%40308systems.com

Sponsored by BooyahMedia.com
and F1 Headlines
http://www.F1Headlines.com/