Ferrari Mailing List: Re: 512 TR NO DRIVE THE REST OF THE STORY!!!!

[clyderomero (clyderomero]

Yes mistakes are made in the cockpit
They are just caught by checklist and CRM proceders
You are in trouble the most when you think you can't make a mistake

Clyde
Sent via BlackBerry by AT&T

-----Original Message-----
From: "Doug and Terri Anderson" <dnt [at] dock.net>
Date: Fri, 27 Nov 2009 19:48:44 
To: clyde romero<clyderomero [at] worldnet.att.net>
Cc: The FerrariList<ferrari [at] ferrarilist.com>
Subject: Re: [Ferrari] 512 TR NO DRIVE THE REST OF THE STORY!!!!

>>Clyde notes - "Bottom line is that even when you have as much experience 
>>as I do mistakes can be made when it comes to work."

Um, OK Clyde, uh, um, just for the record - - - you are a pilot of a monster 
jet aircraft, eh?  Um, uh, what airline?  Just curious - no reason - - heh 
heh.
DOUG
Check sex, seven and eight.


----- Original Message ----- 
From: "clyde romero" <clyderomero [at] worldnet.att.net>
To: "DOUG" <dnt [at] dock.net>
Cc: "The FerrariList" <ferrari [at] ferrarilist.com>
Sent: Friday, November 27, 2009 1:22 PM
Subject: [Ferrari] 512 TR NO DRIVE THE REST OF THE STORY!!!!


> Guys got under the car today
>
> And guess what?
>
> It was not the clutch or throw out bearing
>
> There are 6 8mm nuts that attach the half shafts to the transaxle on both
> sides of the car
>
> Well in April when I did the service you have to remove these in order to
> remove the engine
>
> When I re-installed the half shafts and there associated bolts apparently 
> I
> did not torque the 6 bolts on each side
>
> On the left side all the bolts where disconnected from that side of the
> transaxle, they were there but not connected!
>
> On the right side 3 of the 6 bolts were loose.
>
> I took pictures and will send them on Sunday
>
> But this explains the partial drive not drive issue
>
> Bottom line is that even when you have as much experience as I do mistakes
> can be made when it comes to work.
>
> I was careful not to over torque anything but apparently I did not torque
> these to the correct values
>
> I did this time and was extremely lucky that I did not suffer major
> catastrophic damage to the transaxle assembly
>
> My plan is to put a paint slip line on them and check them often since I 
> do
> drive the car
>
> Anyway it wasn't the clutch and will let you all know how the test drive
> goes but I am not expecting and follow on issues
>
> Stay tuned
>
>
>
>
>
>
>
> Clyde
>
>
>
> Capt. Clyde Romero Jr.
>
> Manpad SME
>
> Clyderomero [at] worldnet.att.net
>
> Mobile 678 641 9932
>
> Confidentiality Notice: This e-mail (including attachments) is covered by
> the Electronic Communications Privacy Act, 18 U. S. C., Sections 
> 2510-2521,
> and is intended only for the person or entity to which it is addressed, 
> and
> may contain confidential or privileged material. Any unauthorized review,
> use, disclosure, dissemination, copying, forwarding or distribution is
> prohibited.
>
> If you are not the intended recipient contact the sender by reply e-mail 
> and
> destroy all copies of the original message. If you are the intended
> recipient but do not wish to receive communications through this medium
> please so advise the sender immediately.
>
> Electronic Transmission Security Notice: E-mail transmission cannot be
> guaranteed to be secure or error-free. The sender does not accept 
> liability
> for any errors or omissions in the contents of the message that arise as a
> result of its electronic (e-mail) transmission.
>
>
>
>
>
>
>
>
>
> _________________________________________________________________
> To unsubscribe or modify your subscription options, please visit:
> http://lists.ferrarilist.com/mailman/options/ferrari/dnt%40dock.net
>
> Sponsored by BooyahMedia.com
> and F1 Headlines
> http://www.F1Headlines.com/
>